Ysi Data Scout Manual de usuario descargar pdf (Pagina 19)

NLN Normal, linear logged scan

NLA Normal, linear average logged scan

NLG Normal, logarithmic logged scan

NEB Normal, event based logged scan

AHI Alarm, logged scan above high alarm limit

ALO Alarm, logged scan below low alarm limit

WHI Warn, logged scan above high warn limit

WLO Warn, logged scan below low warn limi

Table 1, Broadcast ID code description

3.4.3 CHANGE BATTERY

The Level Scout uses two AA alkaline batteries for power. When these batteries are changed, the transducer’s internal battery

condition must be reset so that the percentage of battery charge remaining is accurately reported. This parameter should only be

modified if the transducer’s batteries are replaced. Two types of batteries may be selected as having been installed. YSI recommends

only using AA alkaline batteries in the Level Scout. If the incorrect battery type is selected, the available power indicator will be

inaccurate. Normally, you cannot input a value in the ‘Capacity in mAhr’ box. However, if you select ‘Other’ you may input the

correct milliamp-hours listed for the battery to receive accurate battery capacity readings.

Click the Change Battery button (Figure 3.27) to access the ‘Change Batteries’ window (Figure 3.28). Select the battery type and click

OK to save the change to the battery, then confirm by clicking OK again in the warning window.

Due to the inherent explosion risks of lithium batteries when exposed to

water, YSI does not recommend using lithium batteries in the Level Scout.

Warnin

Figure 3.27

Figure 3.28

YSI Incorporated Data Scout 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Sin comentarios

Ysi Data Scout Manual de usuario Pagina 19